Mas tam verzi 5.0?
Sskus ten proces opakovat a pak aktualizuj na 6.1.
Dalsi navod s mensima upravama.
First of all don't panic your 1950 can be rescued as long as you follow these instructions carefully.
1. Disconnect Ipaq from computer then remove the battery, AC supply and SD card and wait for about 10 minutes for the ipaq to fully discharge.
2. Check your C: drive and completey remove the folder named Ipaq.
3. Download a new copy of WM5.0 from the HP website here.
Kód: Vybrat vše
http://h20000.www2.hp.com/bizsupport...&swEnvOID=2067
4. Download HP bootloader from here
Kód: Vybrat vše
http://www.freetrafficsite.com/BootLoader.zip
5. Open and run the HP ROM setup WITHOUT you Ipaq connected. Then when it comes up with connection error just close it.
6. Connect your Ipaq to the PC via the data cable and use the AC adaptor as a power source. DO NOT put the SD card or battery back in. DO NOT press any buttons or try to reset.
7. Open the bootloader and a window will pop up now double click my computer, double click C:, double click IPAQ, double click SP31892 then click on CEOS.nbf (should be about 63Mb in size) then click on OPEN and let the computer do the rest.
your ipaq should now go into a cold boot. Once everything is running smoothly then you can put your battery and SD card back in.
If you need to repeat this process at a later date you will need to download a fresh copy of WM5.0, I don't know why but for some reason this method only works with a clean WM5.0
if your Ipaq semi bricked durin a WM6.1 update when the Ipaq starts it will come up with that ROM and not WM5.0 and if anyone wants to know it is possible to flash back to WM5.0
Hope this helps someone as it took me a while to figure out after countless button pressing and resetting.
Trochu divne. Kazdopadne napis na XDA forum.
